How to install automatic doors

Views: 48     Author: Site Editor     Publish Time: 2021-07-14      Origin: Site

How to install automatic doors


Step 1: Install the fixed track


Fix the track on the wall, the solid wall can be fixed directly, using self-tapping screws or willow




Nail; square pipe (5x10) or channel steel (No. 16) for hollow wall or overhead installation




Step 2: Install the drive part (motor, controller, terminal block)


First fix the switch terminal on the edge of the track (usually on the right side)


Insert the motor into the track from top to bottom, adjust the position, and tighten the screws


Install the controller in the same way, adjust the position, and tighten the screws


Connect the motor and film plug to the controller




Step 3: Install linkage device (belt, tail wheel)


Insert the tail wheel into the track from top to bottom, adjust the position, and tighten the screw


Put on the belt, trim it to a suitable length and insert it into the belt buckle


Tighten the middle screw of the tail wheel, tighten the four screws in the middle of the tail wheel after the belt is slightly stretched




Step 4: Install the door clamp and connect the door body


Install glass door clamps (perforated door clamps or long door clamps are recommended for glass over 130kg)


Screws on both sides tighten the door clamp, and the middle screw fixes the hanging wheel


Hang the door body connected with the hanging wheel into the track


Observe whether the door is horizontal and vertical, you can fine-tune the hanging wheels to achieve consistency


After adjusting the position, tighten the screw of the hanging wheel


Install hanging wheel anti-dropping parts


Install one side of the belt clip first, align the belt buckle with the position of the belt clip, and lock it tightly


Install another belt clip, adjust the two doors to the actual closed position, and install the belt buckle


After connecting the belt, if you find that the belt is not bend in the same straight line, you can adjust the leather up and down.




The belt clamp position reaches the level


Adjust the door body to the actual closed position, install the middle stopper (buffer head facing right)


Adjust the door body to the actual opening position, install the right stopper (buffer head facing left)




Step 5: Power on and debug


Connect to 220v power supply and push the door to a half-open state


Turn on the switch for simulation test, if the door is opened for the first time, turn off the power




Pull the L/R switch on the controller to the opposite direction


The position will be recorded during the first run, and there will be buffer motions for opening and closing the door in normal operation.




The buffer time and door opening and closing speed controller can be adjusted


MAIL SUBSCRIPTIONS Understand our dynamics in a timely manner.
Leave a Message
CONTACT US

Products

Contact us

Tel: +86-0750-3987161
E-mail: sales@echardwarechina.com
Copyright  2020 EC HARDWARE CO.LTD. All rights reserved . Design by: meiyuseo.com